Apple iPhone Charger Cable 3ft, [ Apple MFi Certified ] 2Pack Lightning Cable 3 Foot,High Fast/Data Sync 3 Feet iPhone Charging Cable Cord for iPhone 13/12/11/11Pro/11Max/XS/XR/XS Max/8/7/6/5S/5/SE.

WHAT IS MFi ?

• MFi is a kind of express license for external accessories produced by authorized accessory manufacturers. It is the abbreviation of ‘Made for iPhone / iPod / iPad’.
• The certification test process is extremely demanding, with a pass rate of only 2%.
• Apple only provides service for Apple hosts for MFi-certified accessories.

FREQUENTLY ASKED QUESTIONS:

• Q1: Does it charge fast ?
• A1: Yes, it charges quickly with the 2.4A (max) current.
• Q2. Does it support data transfer ?
• A2: Sure, syncing is very well and fast.
• Q3: Will it work with phone with cases ?
• A3: The ultra-compact connector is slim enough to perfectly fit for most of cases.

Q: Why does the phone get hot when it's charging?

A: This is normal, because the phone will generate some heat when it is charging. However, the main reasons for the heat are as follows:

1. The charging speed will be faster when the phone power is low, the wall charger will output 9V high voltage, and the phone will generate heat because of the voltage converting process.

2. There are too many programs running in the background of the phone, causing the phone to run at a high load and generate more heat.

Recommendations:

1. Clean up the running program of the phone with high power consumption in the background in time.

2. Don't play the phone while the phone is charged with low power, otherwise the phone will be in a high load state.

About the error message "This accessory may not be supported by device":

The message would appear if you were using a non-Apple wall charger or in poor contact, but even if you are using an Apple accessory, the error can also happen for the firmware problem with iOS.

After analysis, the causes of this problem may be the following:

• Device lightning port contains impurities such as fiber and debris, resulting in poor contact.
• The voltage of the wall charger is too low or unstable, resulting in insufficient power supply.
• The lightning end is corroded/stained, resulting in poor contact.
• Circuit logic problems/system problems with charging equipment.
• The chip or mainboard of the cable is damaged.

You can try the following solutions:

• You can use a pushpin to clean out the pocket lint or debris from the charging port.
• Wipe the Lightning end with a tissue to remove dirt and oxidation marks on the lightning end.
• Use the original charger or MFi authorized charger, because some laptop USB output ports may have insufficient power output.

If it still can't fix the problem, please find us, we will solve your problems ASAP.